-
For $29/mo, we provide access to advanced level technicians who will answer your questions on any Macbook board related matter to the best of their knowledge promptly & walk you through how to solve your problem so you can deliver a working board to your customer.Subscribe Now
Apple MacBook A2338 / Board 820-02020-A / Stuck at 5v 0.00a /
- Thread starter zeydullak
- Start date
What about PPBUS_AON and 3V8_AON?
Check them in diode mode too.
What is the exact ohm value of that short?
Compare with the readings on all big coils.
Compare with the readings on all big coils.
No coil close to 42 ohm?
Checked LC710 too?
Checked LC710 too?
You may have corrosion under audio amplifier; inspect corresponding area.
Should be safe to inject voltage.
Start with 1V and slowly increase; use performant IR camera.
Should be safe to inject voltage.
Start with 1V and slowly increase; use performant IR camera.
"and slowly increase"
42 ohm is not low enough to heat something with low voltage.
However, performant IR camera can detect the culprit before your fingers!
42 ohm is not low enough to heat something with low voltage.
However, performant IR camera can detect the culprit before your fingers!
You can still increase voltage.
However, if UR600 is the only spot dtected, then I recommend to remove it.
However, if UR600 is the only spot dtected, then I recommend to remove it.