Search results

Where find intel fit tool ?

thanks i will try

it's possible download only ME region clean on websites somewhere for any model ? for next repairs futur if needs if yes where to find,downloaded this What is your method to clean me region, I only know this: https://www.ghostlyhaks.com/blog/apple-efi/25-clean-me-region work for all intel...

for diode mode, black probe GND and red probe to pins of u6100 that's it ? reverse ,red probe GND and black probe to pins i have diode mode gets : 1: 0,675 2: 0,611 3: 2,240 4: 0,002 5: 0,680 6: 0,681 7: 0,681 8: 0,450 not replaced clock chip , I must replace U2600 ? i've not donor with PCH...

without U6100 installed on pins of U6100 : diode mode 1: 1.190v 2: 0.830v 3: 2.288v 4: 0.002v 5: 1.202v 6: 0.881v 7: 0.894v 8: 0.572v and resistance : 1: 2.561mohm 2: 2.466mohm 3: 29.76kohm 4: 0.001ohm 5: 2.404mohm 6: 2.424mohm 7: 148.4kohm 8: 25.98kohm

Yes read on GND sorry on pin1 of R5110 to pin2 R5120 in diode mode i've 0,109

Diode mode Pin1 of r5110 1,129 pin2 of r5120 1,192

checked continuity from u6100 to all termination resistor r510 and friends all good :/

PP3V3_SUS line voltage up 1,5v and decrease a 0,8V loop, possible problem with U7200 (area very clean) ? PPBUS_S5_HS_OTHER_ISNS 12,59V P5VS3_EN_L 3,46V stable and P3V3S5_EN_L 0V at Q7221 pin 2 and 5 PP5V_S3 3,3V up and decrease PP3V3_S5 3,3V up and decrease

pins 1 at 8 with U6100 removed 1,185 0,828 2,289 0,001 1,201 0,880 0,891 0,583

U2600 not replaced i will Check diode mode on all pins of U6100

u6100 corroded, cleaned area and checked resistance arround same problem

how to check U2600 problem ?

another board with liquide damage no green light before replaced smc green light ok after replaced smc power on for 2 seconde and stop start 2 seconde and stop loop I have replaced smc twice and same problem pubs_g3h 12,56V and pp3v42_g3h 3,42V and green light OK possible problem with SPI ?

Solved after replaced MCP no short to gnd PP3V42, replaced bad fuse for backlight and ISL destroyed by customer (ppbus low). (display port not work fuck) Thank you I would not find that this comes from MCP

You have another method than this for clean me ? Interested to do it myself

Pin 4 of Y2810 to GND 7,2 Mohms Pin 1 7,20 ohms Does that mean the MCP is dead ? I have new chip but A2, in board it's A3 (on Mac mini 2010 succeful MCP89MZ-A2 to MCP89MZ-A3 but in the other direction probably work ?)

nothing heat

ok 1V for beginning ...

removed L6995 short to gnd pin 2 PP3V42_G3H :/ what do I have to do ? inject voltage in PP3V42_G3H ?