Search results

I already changed by a new but I'll put another again.

Check about R7051/ 52(?) and R7021/22 R7005. This resistances ares OK.

F7040 removed...

PPBUS_G3H =1.10Volts.......... On fuse F7040: with magsafe connected only 1.10Volt, and with battery connected only 11.30Volts....

another smc soldering: magsafe board is ok (820-2565-A) PPDCIN_G3H = beetween 16.70 and 16.93V. SMC_BC_ACOK_VCC=beetween 3.39 and 3.46V. SMC_BC_ACOK = beetween 2.33 and 2.38V.??? About PP3V42_G3H : Pin 5 of U6901 is stable with 3.46Volts. green light blinking,I think there's a problem...

ok let's go.... thanks

Must I replace smc by another?

Original SMC, green light very low.....?? I try to boot board, no fan, no battery indicator, no boot..... (no boot with just battery)

Little problem about SMC, I have desoldering SMC and PIN 125 (NC_SMC_GFX_OVERTEMP) was abscent...... what would be the consequences?

all right......

I removed the LCD connector fried, and I weld another LCD connector. Now I ask you if according to the new pictures you see, it would be better to weld a new one, that's all :)...

Do you think that's I replace lcd conector by new? (this connector comes from a donor board...)

ok you are right 2 pins are fried.......;)

L9008 and C9010 were removed, and now Pin 3&4 of LCD connector are not anymore short to ground.....

Ok , I ca,'t to be sure that the original smc is the original smc , because, the glue around the smc was abscent, so I have think to change , to be sure it was me who replaces him... But I'll give the original when buying...

The measures they are in the right place?

Pp3v3_s0 ........

L9008 is dead, and PP3V3_S0 is short to ground???? an idea?

screen of LCD connector. replace F9700 fuse... cable be fried that's sure.... LVDS connector pin 3&4 short to ground......

the test with battery