Search results

Yes, I'm actually testing it alone. But even with the battery is same. I found P5VS2TPS_PGOOD wrong reading on diode mode. Q6070 relaced and now it's correct, but still same.

Yes, still cycling. PPVDD_DISP_AWAKESW - 0.160 / FlexBV-0.210 All the lines are matching a working LB apart of this above.

Q5216 replaced and CHGR_AUX_DET is 0.545

R5215 is supposed to be 750k and was 450K R5216 is supposed to be 255k and was 149K After replacing both the CHGR_AUX_DET is now 1.28V CHGR_AUX_DET still 0.466 in diode mode.

R5215 Pin 1 - CHGR_AUX_DET - 132Kohm / Diode 0.470 - On a working board according to FlexBV it should be 0.549 Pin 2 - PPDCIN_AON_CHGR - 70Kohm / Diode 0.620 AUX_DET_SHORT - 0V P0V9_LX0_NAND0 - 0.320 P1V2_LX0_NAND0 - 0.309 PP2V5_NAND0 - 0.307

Battery charging / PPBUS IC RAA489900 - Replaced and same results.

PPDCIN_AON_CHGR_R |P_IN 5.13V CHGR_AUX_DET 0.86V VDDA 4.6V VDDP 4.6V EN_MVR 4.5V ~ 4.7V AUX_OK 1.78V CHGR_AMON 0V CHGR_BMON 0V

The Mac is liquid damaged. Keyboard and probably screen. No power. On the LB there was liquid on the U5700, UT00, UF750, around the UR630. There was some liquid coming out from under the shield opposite the CPU. The customer took it to me 30 minutes after the liquid accident. On the amp meter it...

The T2 that I replaced is from same lb model. But I just realize that the original T2 from the board I'm trying to fix is h9hknnnBRumuvr-nlh and the donor T2 is h9hknnn8Kumuvr-nlh. Both board has 1TB storage. Is this relevant? LDO0: 0.195 normal reading on tis line is 0.253. I already remove...

Same results shorting 3V3_S5 to ground.

Revive and restore.

NANDs replaced and same issue. Do you think by any chance it could be the U1200 - PCH?

I have tried with a second known good battery and another trackpad and presents same behaviour.

T2 and it's ROM replaced. Exactly same behaviour. I also tried to flash another firmware into the ROM chip and with a firmware from another board it goes to DFU and when I try to Revive it. the LDOs cycle once and then Revive fail. I try to change the firmware with the original board SN and...

Could it be an issue with the T2 ROM?

Data is not important on this device. Shop is dead at the moment just a few jobs. I will try that and post back. Thanks for you help.

Is it possible to replace the T2 on this?

Good battery. Tried revive and still same.

In DFU mode before staring Revive option all the power lines mentioned above are stable. As soon as I press Revive or Restore it starts to cycle again.

U7800 replaced an same issue. Revive gets stuck on Installing system. Do you think the T2 ic itself is faulty or it still could be software?