Search results

Yes it charge the battery it draws 2.13A when battery is connected

No voltages on any coils except L7030=8.2V

Board draws 20V 0.00A Ppbus_g3h=12.60V Pp3v3_g3h/rtc=3.309v Pp5v_g3s=5.1v Pp3v3_g3s=3.3v Pp3v3_s5=3.3 Pp5v_g3h_ldo=5.1v I have tried dfu... completed and shows padlock on the host screen but no display

Channels pls I can’t relate.

CC1=0.608 CC2=0.609.. I can see U3200 blinking On thermal camera when the ammeter restarts

CC1=0.608 CC2=0.609.. U3200 was lite on and off On thermal camera So u3200 is the restarting cd3215

PPBUS_G3H diode mode is 0.434 3V3_G3H is 3.433V

i mean the first type-c port PPBUS_G3H is 0V PP1V8_UPC_XB_LDOA1.793 PP1V8_UPC_XB_LDOD=1.799V PP1V1_UPC_XB_LDO_BMC=0V PP3V3_UPC_XB_LDO=3.383V U3100 PP3V3_UPC_XA_LDO=3.299V PP1V1_UPC_XA_LDO_BMC=0V PP1V8_UPC_XA_LDOA=1.8V PP1V8_UPC_XA_LDOD=1.8V.. Have been testing the board alone on the desk

the board was working perfectly but not charging,i took the board out and found C3208 burnt removed and replaced.. Now system draws 5V no current...the first port restarts the ammeter and have changed the both CD3215 U3200 PP3V3_UPC_XB_LDO=0.500 PP1V1_UPC_XB_LDO_BMC=0.527...

The board is gone?

Bad PCH?

L8060-0.001 L7900-0.001 L7960-0.047 L8030-0.147 L7730-0.182 L7430-0.003 L7410-0.003 L7420-0.003 L7670-0.440 L7690-0.370.. PP3V3_S5 is present and stable

Pp3v3_ldo3v=3.302v Pp5v_ldo5v=5.025v Pp1v25_vref=1.253v... SMC_PM_G2_EN is 3.417V stable

I changed J5260 it now works😃 Thanks...

There is no 3volts on it .. I found 0.362 diode mode to ground on one of the peel pads which i think the resistance is for 3V3_g3h

Should I change j5260 or how can i check if it gets 3V3_G3H

board draws 20v no current.. All power aliases are present PP3V1_RTC=3.060V PP3V3_S5G=0V PP5V_LDO5V=3.4v

Still the same with board alone on desk HALL_SENSR_LEFT =3.4V HALL_SENSR_RIGHT=0V After I approach magnet to j5260

Where should i place the magnet to simulate lid action