Recent content by handydandy1971

Okay...Thank You Duke!!!..I will search around on eBay for one...I appreciate Everyone's Help....Thanks Again :)

Damn AUTOCORRECT ON THIS PHONE!!!...Lol

Is there anywhere that I can Pirchase a Preballed SMC for this model? I don't have a stencil of Balls...InDO have another 820-3115 Board but I can't renal the SMC chip once I remove it...

Unfortunately I Don't have a Scope...

I am going to also check those 2 Data lines coming off of U7000 also...Anything else I can check?

Thank Tou for the Quick Response Duke :) With the Red Probe on ground and Black probe on Pin 4, Pin 6 of the Battery Connector I get 2.399kohms on each pin with the Multimeter set to Diode Mode?

Also...What should the Proper Diode readings be for data lines SMBUS_ BATT_SCL & SDA?

Correction...I Meant I replaced R5087 Which is a..........(470K/5%/120W/201) Resistor With a (470K/5%/1/16W/201) Resistor.

Replaced U7000 Again and I am getting 3.4ohms on Pin 17/18 now...I have a Green Light on Charger But it Still is not recognizing the Battery and I am still getting 12.26v On F7040 with Charger attatched and 11.98v with Just the Battery attached. I Also removed the Rubber Around the Corners of...

Correction...I meant I get 0.04ohms Between pin 17/18 on U7000...

Hi Guys, I have a 2012 A1278 (820-3115) That had Very slight Water Damage around the Q5480 and R5481 Area. After Cleaning the area It still Had No Green Light so I Replaced U7000 and Now it Runs Perfectly Off the Charger But does not recognize Battery and there is no orange Light...I checked the...

Then I put a pretty Good Amount of Amtech Flux all around the SMC and heated it up Pretty Good at about 350 Degrees then a Little Bit at 400 Degrees it was Bubbling pretty Good but not Hot enough to melt the Solder and...Now it Works PERFECTLY!!!...Thank You Duke and Everyone for Your...

Thank You Duke!!!!...I cleaned the SMC Area Extensivly

Thanks Duke...Should i Flux and heat the PCH Also?...So Weird considering there was NO liquid damage Anywhere near the SMC...Not even a discolored trace it Test Point anywhere in the area...I will give it a shot though as I trust in Your expertise...I'll let you know how it goes...How much heat...

Okay...I have checked EVERYWHERE on the Board under the microscope and see no corrosion or corroded caps...The only place there was a small amount of corrosion was around the J6995 area...Its Nice and clean now...the Laptop works Absolutely perfect until I turn it off and then it wont restart...